Manufacturer: NEC
Model: NEAX 2000 IVS
Software Version:
Hardware Requirements: PN-4LC card for interfacing to a voice mail system
Voice mail setup is the same as for the NEAX-2400. See the VoiceTrak integration for the NEAX 2400 for additional information.
Make sure MWL codes match the switch.
Important: All other VoiceTrak parameters must be set to Default.
Use Tone/Cadence file: NEC2000.NEC
Notes:
Transfer to fax machine. The tone table includes incoming fax detection. You may add an "X" type mailbox which transfers to a fax machine. Also add a line to the VOICE.BAT file which says: 'SET FAX_BOX=xxx' where xxx is mailbox for the fax machine. Not all fax machines send good CNG tones and will not transfer, but if fax tones are detected, the call will transfer to the extension specified in the FAX_BOX setting.
Display sets will show "VMM" and non display terminals will have a message waiting light when new messages have been left. The lights will be extinguished when the mailbox holder calls in to retrieve messages. For a single line phone with MWL requires 80 volt power card.
Set forward: <Speaker> <Fwd button> <Ext # to fwd to> <Speaker>
To cancel forward: <Speaker> <Fwd Button> <Speaker>
The ports used for VoiceTrak must be in the same UCD group and be designated as voice mail ports. Programming for the MCI is included in ETI-014 dated April 8, 1986, and ETI-121 dated February 1991. Programming used for this installation was:
ASYD | Index | Contents |
1 | 27 | 00 |
1 | 28 | 20 |
1 | 29 | 08 |
1 | 34 | 15 |
1 | 70 | 25 |
1 | 78 | 03 |
1 | 140 | 72 |
2 | 06 | 91 |
2 | 07 | 05 |
2 | 15 | 02 |
1 | 247 | 38 |